3/3/2024 0 Comments Fanned fretboard template![]() I can pull that file into DraftSight, and from their export the drawing as a PDF after it's cleaned up a bit. I found a website that does all the calculations for practically any fingerboard, and the best part is that it can kick a file out in. There are two holes in the plastic for the clamp cauls to go through. The risers are roughly 1/4", so a 7/32" thick fingerboard fits nicely under the reticle. The bottom of the sled has a slot routed in it to accommodate the blade and stiffeners. I then ran the sled through a few times, gradually raising the blade until it just scratched the surface of the plastic. The combination had no problem holding things in place.įor lack of a better term, I included an aiming reticle by epoxying it on top of the clamp riser bases, and the clamp screws go through the base of the clamp, the reticle, the risers, and the base. The bolt and rubber caul on the clamp aren't really long enough, so I ended up using a washer and a magnet on top of the blank to add a little more pressure. Some 120 grit sandpaper helps hold things in place. These two are a couple I picked up from Harbor Freight. ![]() The fingerboard blank is held against the sled base with a couple toggle clamps. There's nothing exceptional about the sled itself, but it's dead simple to use. The concept is extremely simple, and it seems to work just fine. I finally got around to designing, building and testing out a sled for cutting fanned fret slots.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |